Less water in the radiator causes the engine warm

Car Radiator when you see smoke or a burning car on the streets, of course there is something wrong in the engine. One reason is lack of water in the radiator causing the engine heat.

In addition, the engine heat also caused by clogged radiator pipes, dirt and damage the radiator fins on the fan and thermostat coolant system.

In fact, less accurate ignition system, damage to the channel system of petrol, the exhaust is blocked, problems dibble, have a friction brakes and how to manage vehicles also cause poor engine heat.

Engine that is too hot can invite danger if late act because it can cause your vehicle smoke, fire and subsequently exploded.

When your car engine too hot, with a roadside stand in the shade. You should not panic, but stopped the car and try to do their own inspection first.

The first step, open the bonnet to cool the vehicle while the engine and check one of the sources mentioned just now. After that, check your vehicle radiator to ensure leaks do not occur in that section.

After that check the fan belt. If there is a leak in the radiator or a broken fan belt, switch off the engine. If no leaks in radiator and fan belt is still good, switch the vehicle engine and the instantaneous rotation higher than usual.

Step is to allow air flow through the radiator fins with a total of many. Water in the radiator will be cold and water pump will work more quickly so that coolant water can flow better.

Not long after that the engine temperature will decrease. Then just drop the rotation of the engine and open the radiator cap. Closing should open carefully to avoid dangerous spray of hot water and steam out of the radiator.

Fill water into the radiator slowly while the engine is still in normal circumstances and switch off the engine if already a cold. If too little water in the radiator, it will cause the engine heat and steam will exit from the radiator.

In this case, switch off the engine immediately and check the radiator.

Firstly, open the radiator cover and get behind the players knock using screws and slowly rotate the cloth.

Hold up to close to prevent steam in the radiator to flow out and into low pressure in the radiator. After it was released a veil.

If, there is a leak in the radiator especially at the connection or paipnya channels, switch on the engine rotation is higher than usual and check the connection is.

Condition is important because there is some leakage can not be seen in a low engine rotation. If there is leakage, tight screw fastener and loop fastener if damaged, use wire instead.

If you have a leak, wrap the damaged section with adhesive tape and strong with wire. You must remember that improvement only for a while before the vehicle was brought to a workshop near.

Radiator pipe blockages arising from the crust or rust will affect the water cycle or even cease to have caused a lot of water.

The situation could be known by checking the flow of water at PILI disposal. If water does not flow smoothly or not at all out, the situation shows the pipe clogged radiator.

To fix it, open the engine block PILI water until the water coolant can be issued. Open the radiator and wash off with clean water for approximately 10 minutes to remove the crust or rust.

Impurities in the radiator fins because of dry leaves, insects or mud that stick to the face will cause radiator coolant air flow will be interrupted until the water becomes hot.

Impurities on the surface can be cleaned using high pressure air or water menyemburnya use. Confusion on the steps also cause a vehicle operating vehicle engine heat.

Although the engine is in good condition but when the vehicle is climbing a hill or carrying excessive loads, it can be hot.

Engine can be cooled back to the way you stop the vehicle briefly, opening bonnet, switch the engine on high rotation or fill radiator with cold water.

User guard car tires

Tires are among the most important components in a vehicle. Reluctance and negligence care and change the tires are not flowering or often referred to as bald tires may invite problems on the road.

Tires play an important role during braking and must be durable to handle the pressure and road surface is sometimes uneven. Tires must also provide comfort when taking turns and steering control in any situation.


Typically, major tire manufacturers in the country is providing safety tips tire to the driver.

Here are the few useful guidelines:

* Immediately change the tire if the flowers are thirsty. Tires easily slipped way, affected by the braking effect and less sensitive in terms of grip. In the wet road conditions, vehicles may be difficult for Chevrolet and driver control.

* Selection of tires is important for safety, comfort, control and economy.

* Sudden braking can cause the tire to skid. Check tire pressure at least twice a month when tires in winter conditions. Manufacturers also stressed the priority to maintain tire pressure.

* Do not drive in a damaged tire. Change or repair as soon as possible.

* Immediately repairing tires is not normal. Make a habit to check pressure, wheel alignment and round. Avoid bad habits when driving such as driving too fast, braking suddenly and took a dangerous turn.

* Make sure the replacement tires are in good condition and can be used and have sufficient wind pressure.

* Do not combine with radial tires and radial tires without. At high speeds, the situation is causing interference which resulted in loss of vehicle stability control and serious injury.

* Always make sure the screws are properly installed and the wheels are not too tight. Impossible to open with the opening screw tire tire if it is too common with machines opening tight tire air.

* Do not let the tire load more. Chart weight and wind pressure is usually open in the wind to fill in any stations. |

* Tires can only accommodate a maximum capacity if it has a maximum wind pressure.

* Do not install tires that have been used at will unless you know its history. It means, if your lucky your sister to donate a set of tires because he want to buy new tires.

eat engine before the journey

To keep the vehicle can be used in a long tempo, drivers do not always recommended to do sprint, brake and deflection of a sudden, except in desperate circumstances.

PRACTICE switch engine and continue the road is not good. Preferably after the engine is switched on, leave two or three minutes before starting the journey. This is important to ensure that the engine in hot conditions.

During the process of heating, lubricating oil will flow to all parts of the engine. If the engine continues to be charged before heated, this means that the engine had to work when the oil has not reached every part of the necessary smooth.

Thus, each section that rub against each other will suffer thirst due to heavy encountered engine will more quickly damaged.

Calculated engine hot enough when needle water Air temperature rose slightly. Heating process also applies to the transmission system and other parts of the move. When already started driving, do not continue to accelerate. move slow for a while before the sprint.

In addition, the engine also can not be charged roughly. Do not let the engine work in a low gear with too long, for example, three gear when climbing hills.

Practice 'pull' low gear a long time to power acceleration also means that health is not healthy for the car. If left too long in a state that, in addition to reduced engine power, the engine will also be too hot. Engine that is always in a state of overheating will quickly damaged.

The engine will also be working more than the maximum rotation axle in a state of idle or gear at the time of transfer to a lower position (for example, from gear to gear two of three) performed at the time the vehicle is still moving with high speed or when the vehicle is gliding on the road steep). So, beware.

To keep the vehicle can be used in the long term also, recommended drivers do not always do sprint, brake and deflection of a sudden, except in desperate circumstances.

In addition, avoid the too frequent use of brakes on a steep road or at high speed to avoid problems with restrictions steam. Avoid also stepped dibble board when not needed and do not move the gear roughly, regardless of manual or automatic gear.